Jump to content

Bearing surface

From Wikipedia, the free encyclopedia

This is the current revision of this page, as edited by MrRaindrop75 (talk | contribs) at 23:21, 13 March 2024 (added missing commas). The present address (URL) is a permanent link to this version.

(diff) ← Previous revision | Latest revision (diff) | Newer revision → (diff)
The bearing surface describes the contact area between two objects used as datum. It is often the underside of a screw head (male seat, marked A) or a flat at the end of the screw thread (female seat, marked B).

A bearing surface in mechanical engineering is the area of contact between two objects. It usually is used in reference to bolted joints and bearings, but can be applied to a wide variety of engineering applications. The choice of bearing surface depends on the application, load, speed, and operating conditions, and the design must be able to withstand high loads, resist wear and corrosion, and operate at high speeds.

On a screw, the bearing area loosely refers to the underside of the head.[1] Strictly speaking, the bearing area refers to the area of the screw head that directly bears on the part being fastened.[2]

For a cylindrical bearing, it is the projected area perpendicular to the applied force.[3]

On a spring, the bearing area refers to the amount of area on the top or bottom surface of the spring in contact with the constraining part.[4]

The ways of machine tools, such as dovetail slides, box ways, prismatic ways, and other types of machine slides are also bearing surfaces.

See also

[edit]

References

[edit]
  1. ^ Smith 1990, p. 38.
  2. ^ Fastener terms, archived from the original on 2008-11-02, retrieved 2009-06-29.
  3. ^ Low & Bevis 1908, p. 115.
  4. ^ Helical Compression Spring Terminology, archived from the original on 2010-11-01, retrieved 2009-06-29.

Bibliography

[edit]